Operation is subject to the following two conditions (1)this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation levision reception, which can be eįederal Communications Commission Authorization and Evaluation Division ApLetter of Authorization Radius Networks, Inc. Consult the dealer or an experienced radio/TV technician for help This device complies with part 15 of the FCC rules. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Increase the separation between the equipment and receiver. Reorient or relocate the receiving antenna. If this equipment does cause harmful interference to radio or t determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: However, there is no guarantee that interference will not occur in a particular installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. L'exploitation est autorise aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible d'en compromettre le fonctionnement FCC Statement Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Le prsent appareil est conforme aux CNR d'Industrie Canada applicable aux appareils radio exempts de licence. This product meets the applicable Industry Canada technical specifications.
The term IC: before the certification/registration number only signifies that the Industry Canada technical specifications were met. (2) This device must accept any interference, including interference that may cause undesired operation of the device. (1) This device may not cause interference and Operation is subject to the following two conditions: +3dBm TX Power Enclosure Enclosure Firmware IP67 Rated UL 94 V-0 Flame Rated Multiple interleaved advertisements iBeacon, AltBeacon, AltBeacon TLM, Eddystone UID, Eddystone URL, Eddystone TLM, Eddystone EID, Eddystone ETLM IC Statement This device complies with Industry Canadas licence-exempt RSSs. Open to alternatives Sensor Accelerometer Motion and fall detection triggered Power Source 1 x CR2477 1 x 1,000 mAh Battery Life 12 Months Based on 100Hz advertising rate at Open to alternatives This is based on the Nordic NRF52832 SOC as a likely candidate architecture.
#RADIU NETWORK RADBEACON DOT BLUETOOTH#
Category Bluetooth Bluetooth Low Energy v5.0 Requirement Additional Detail Partner Comments Microprocessor ARM Cortex M4 Flash 512kB of flash memory RAM 64kB RAM Range 100m at max tx power Antenna Trace or Chip, Omnidirectional Advertising Extensions, GATT Services, L2CAP Channels This is based on the Nordic NRF52832 SOC as a likely candidate architecture. The tent enclosure should be really waterproof to allow the tents to be washed in the restaurant. The tent beacon has an accelerometer to extend battery life by trigger on accelerometer event. The idea is to redesign the electronics to use a larger battery.
#RADIU NETWORK RADBEACON DOT MANUAL#
User Manual RadBeacon Locator Tent Model: RBT-003 Bluetooth Smart 5.0 proximity beacon powered by 1 CR2477 Lithium battery with tent form factor for extended battery life and a waterproof enclosure.
0 kommentar(er)
